Wiring Your Unfinished Garage

 

You’re looking around at your unfinished garage and realize you need more outlets and lighting. Before getting started, keep a few things in mind: If you are leaving the walls and ceiling open, you’ll have to use the framing members to protect and support the wires. Do not span stud or joist spaces with wires, and keep the cables closely hugging the studs, plates and ceiling joists.

Always make sure you’re doing everything safely and up to code. If you’re just not sure, don’t hesitate to bring in a professional electrician. Lastly, if you plan to close up the walls later on, you’ll have to rewire. So, what’s next?

Next Steps

You’ll route the cable along studs, top plates and ceiling joists, along the framing member that leads to the next box. Keep cables on vertical surfaces—not on the tops of walls. Plan your wiring and put up all the electrical boxes.

Next, run a cable from one box to another by pulling cable off the coil, stripping at least 8 inches of sheathing off the wires and threading the wires and about 1/2 inch of sheathing through the wire opening in the box.

Untwist the cable and staple, staple, staple! Do this at least every 4 feet to the framing, preferably more.

Important Tips for Garage Wiring

When you get to the next box, stretch out the cable and mark the entrance point on it, cut the cable about a foot long, strip the sheathing and feed the wires into the box. Nail in the staples near the box.

NOTE: You’ll have to hold all wires at least 1-1/4 inches from the back and front surface of studs and joists.

Electrical boxes may have metal or plastic cable clamps that are built in. Many duplex boxes only have knockouts. Staple cable within 8 inches of boxes without clamps and within 12 inches of boxes with clamps.

And don’t forget: If your garage has a wall made of concrete or is already dry walled, cable installed on these exposed surfaces has to be protected by conduit.

CC Air Can Help

Have a concern with your electrical, plumbing or air conditioning? Central Carolina Air Conditioning, Plumbing and Electrical is here to help! We offer 24 hour emergency service 7 days a week!  Give us a call! 1-800-461-3010 to speak with our customer service agents that can answer your questions or schedule an appointment!

Wiring for Your Home Office

 
imagesMore and more people are working from home. You can have the best speed and performance in your home office if you set everything up properly and don’t cut corners.

You’ll likely need high-speed Internet and networking. Structured wiring is a data delivery system that can carry phone, fax, broadband, networking, and video/television technologies. The system has three parts: a panel where outside service enters the home, wires and cables throughout the house, and connecting hardware. You can get a prepackaged system, but that means you may have wasted outlets or no outlet where you need one. It is a good idea to develop a home-office plan before you wire. Figure out where the computer, printer, phones, and media will be set up and where conference calls will happen.

The system is installed the same way regardless of whether you have a new construction or are remodeling. The preferred method is the “star” layout, where each outlet extends individually to the service panel. This will allow for flexibility and help to figure out any problems. There are options for older homes so you don’t have to open up walls. Wires can be fished through walls.

If you’re not comfortable doing such a big project on your own, hire a professional. Not only do you want it to be installed correctly but you also want to make sure you have create necessary flexibility to accommodate future expansion. Costs vary, but the system typically ranges from about 1 to 3 percent of a home’s value.

Have a concern with your electrical, plumbing or air conditioning? Central Carolina Air Conditioning, Plumbing and Electrical is here to help! We offer 24 hour emergency service 7 days a week!  Give us a call! 1-800-461-3010 to speak with our customer service agents that can answer your questions or schedule an appointment!

Updating Your Kitchen for High-End Appliances

pexels-photo-213162

Professional-style kitchen appliances are becoming increasingly available and popular in everyday homes. If you’re considering upgrading your kitchen by installing these types of appliances, there are some things to consider and tips to make sure it’s all done safely.

First, think about your kitchen size. Many kitchens will simply be too small for these items. You will need about three feet of space for the refrigerator, three feet of freezer space and four to five feet for a commercial-style range. Also, some of the ranges are very heavy and require a special base. Many manufacturers do offer smaller models, so check their specifications.

Consider the burners and ventilation hoods. Many high-end ranges and cooktops have burners that can exceed 20,000 BTUs and require hoods that can handle up to 1,200 CFM. This is almost 10 times the typical amount. To ensure proper ventilation, add up the total BTUs of the range burners, divide by 100, and then you’ll get the number of CFMs needed. For example, a range with a total output of 70,000 BTUs should be equipped with a hood capable of moving 700 CFMs. This will help prevent issues with heat, grease, smoke and moisture.

Houses with high-power hoods may need to install an air makeup unit to replace the air that the ventilation is removing from the home. This is because the removal of too much air can be dangerous with the use of
chimneys and furnaces.

Lastly, any customizations involving electric extensions or plumbing work is best handled by a professional if you aren’t sure of what you’re doing.

Have a concern with your electrical, plumbing or air conditioning? Central Carolina Air Conditioning, Plumbing and Electrical is here to help! We offer 24-hour emergency service 7 days a week!  Give us a call! 1-800-461-3010 to speak with our customer service agents that can answer your questions or schedule an appointment!

Holiday Lights and Electrical Safety

christmas wishes

Many of us are already taking out those boxes of holiday decorations or starting to shop for new décor. With all of the lights, though, come safety concerns. How can you make sure you’re lighting up your home without risking fires or electrical injuries?

  • Before getting started, plan your displays. Look for outlets and figure out what you can reasonably do before you go into a decorating frenzy.
  • When shopping, make sure the product has a label showing that it has gone through independent testing by a recognized lab, such as UL or ETL.
  • LED lights are more energy efficient, last longer and are more durable than incandescent lights.
  • Don’t use items intended for outdoors inside, or vice versa.
  • Make sure you’ll be notified of any recalls by sending in the product registration forms.
  • Inspect older decorations for any loose or damaged wires or connections.
  • Unplug before replacing bulbs or fuses.
  • Make sure cords are not pinched in windows, doors, etc.
  • Don’t overload electrical outlets with too many items at once.
  • Do not connect an extension cord to another extension cord or place them in high traffic areas or under furniture, carpets or rugs. Do not run them through walls or ceilings.
  • Do not connect more than three strands of incandescent lights together.
  • Outdoor lights should be plugged in to circuits that are protected by ground fault circuit interrupters (GFCIs).  (You can buy portable GFCIs.)
  • Protect lights from the wind by fastening them to firm surfaces but make sure this is not done in a way that could damage the cord’s insulation.
  • Turn off all holiday lighting before going to bed each night.

Have a concern with your electrical, plumbing or air conditioning? Central Carolina Air Conditioning, Plumbing and Electrical is here to help! We offer 24 hour emergency service 7 days a week!  Give us a call! 1-800-461-3010 to speak with our customer service agents that can answer your questions or schedule an appointment!